The R-type hot oil pump is the second generation product developed by our unit on the basis of digesting and absorbing foreign oil pumps. The basic structural form is a single-stage single-suction cantilever foot-supported structure. The inlet of the pump is axial suction, and the outlet is vertically upward in the center, and the motor Installed on the base.
< /> The support of the second R-type hot oil pump adopts the structural form of double-end ball bearing support. The front end is lubricated with lubricating oil and the rear end is lubricated with grease. There is an oil guide pipe in the middle to observe the sealing condition and recovery at any time. Thermal oil.
< /> The three-R hot oil pump adopts a combination of packing seal and mechanical seal. The packing seal uses high-temperature resistant packing and has good thermal adaptability, while the mechanical seal uses mechanical strength and high wear resistance. Good carbide materials ensure sealing performance under high temperature conditions. The third-generation polytetrafluoroethylene is used as the lip seal, which greatly improves the sealing performance. It is twice as reliable as rubber seals and has extremely strong corrosion resistance.
LQRY hot oil pump